|
|
|
Terminal
Crimp Process Verification Report |
|
|
|
|
|
|
Report No.: |
|
|
|
Project Name: |
|
Manufacturer: |
|
|
|
Project Type: |
|
Preparing Location: |
|
|
|
Requested By: |
|
Request Date: |
|
|
|
|
|
|
Prepared By: |
|
Completion Date: |
|
|
| Insulation
Crimp Cross Section |
|
|
Observations |
|
| Evaluation based on IPC A-620 sec. 5.1.1 |
|
|
|
| Based on observations, classify
this insulation crimp cross section as acceptable, process issue, or design
issue. |
|
|
| Check
points |
Classification |
|
| Insulation
crimp wings contact at least 180 degrees of the insulation surface. |
Acceptable |
|
|
| End
of each wing contacts the wire insulation. (Overlapping crimp has end of one
wing in contact with insulation.) |
Acceptable |
|
|
|
|
|
| None of the wings penetrate the insulation. (This is not allowed
by Whirlpool) |
Acceptable |
|
|
|
| Crimp is symmetrical. |
Acceptable |
|
|
| No insulation extruded between the wing gaps. Wing gap is not greater than 45 degrees. |
Acceptable |
|
|
|
| Additional
Comments: |
|
|
| |
|
|
|
|
|
|
|
| Category |
Measurement |
Specification** |
Meets Criteria? |
|
| Height* |
3.11 |
NO SPECIFICATION |
Yes |
|
| Width* |
3.496 |
NO SPECIFICATION |
Yes |
|
| *Measurements
are from a 1 piece sample set |
|
|
|
|
|
|
|
|
|
| **
Reference Only |
|
|
| Measurement
Criteria |
|
|
1. C-4 - 7.4.4 |
|
|
2. IPC A-620 |
|
|
3. SAE/USCAR-21 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|